Nightmare Freddy Jack Hand adult and pocket size High heat full color

11" adult

3.5" pocket

Screen print (full color plastisol ink) transfer - THIS IS NOT A DIGITAL FILE, you are purchasing a ready to apply print that will be shipped to you and you must apply it to your garment with a heat press

This is not a completed garment, shirt shown as an example only, this is ONLY the transfer to apply with your heat press to your own materials

Ships ready to apply to cotton, poly, or cotton poly blend fabrics

How To Apply Our Transfers
Applying our transfers is super simple. Follow the steps and instructions below to achieve perfect results on your next project!

1) No Teflon Sheets, Covers or Pillows. Ever.
Never use teflon sheets, covers or pillows with any of our plastisol formulas. They dissipate the heat too much, resulting in a poorly applied transfer.

2) Calibrate Your Heat Press.
You will need to use a quality Infrared (IR) Temperature Gun (Contactless) to ensure your heat press is heating evenly and accurately. You should do this each and every time you start a new pressing cycle.

3) Pressure, Pressure, Pressure.
Plastisol transfers will give you a quality and long-lasting decoration solution, but you HAVE to ensure you are using adequate and even pressure. This will ensure the formula properly adheres to your garment. Not using enough pressure can result in poorly applied plastisol transfers.

4) Water resistant, waterproof, and fireproof garments:
We recommend testing a sample on your item before production. Water resistant, waterproof and fireproof garments may not accept a heat transfer application.

High heat soft feel Formula
NO TEFLON SHEETS, COVERS or PILLOWS

Temperature: 350-375 Degrees Fahrenheit **VARIES BY PRESS - if your press runs hot, you'll need to do it lower. start low and if not adhering fully, increase heat by 10 degrees and repress, or add a few seconds at 350
Time: 7-15 Seconds

**temp/time VARIES BY PRESS - if your press runs hot, you'll need to do it lower. start low and if not adhering fully, increase heat by 10 degrees and repress, or add a few seconds, and alternate increasing time/temp until it's adhering fully. Peel very slowly at one corner to check and if needed, put it back down and repress**
Pressure: High Pressure (8-9 Manual, 60PSI Automatic) -- Enough pressure is critical
Peel: Hot Peel