Choose your material and color color (sold in set of 2 panels for 4.1” claw clip)
1/16" thick acrylic panels - use with uv dtf design transfers sized to fit the panels, transfers sold separately
sublimation board - we can print sublimation transfers of our designs or yours sized to fit the clips, transfers sold separately
General Sublimation Instructions • Preheat the heat press to 380-400°F. Set the time to 50-60 sec., set pressure to medium-heavy. • Remove protective masking and place product blank face down onto the printed transfer. Secure the product blank to the transfer paper with heat tape. • Place blowout paper or Teflon sheet onto the heat press platen. • Place the product blank with attached transfer onto the sheet blowout sheet, with transfer side up. • Place another piece of blowout paper or Teflon sheet on top of the transfer sheet. • Close and press for recommended time. • When finished, open heat press and remove the product. Remove the transfer paper and discard.
leatherette - use with uv dtf design transfers sized to fit the panels, transfers sold separately
Some specialty preprinted pans are listed and can be added to clips without any decals as they are already printed with the design shown
Acrylic may have protective coating on one or both sides to prevent scratches and charring while being cut, these can be peeled off before applying decals
Please note: Listing is for blank panels only. Design decals and claw clips sold separately. example photos shown of decals on panels
