Ir directamente a la información del producto
1 de 2

Puttin on the Printz

UV DTF Hair claw clip transfer for acrylic, leatherette blanks and unisub sublimation hardiboard

UV DTF Hair claw clip transfer for acrylic, leatherette blanks and unisub sublimation hardiboard

Precio habitual $2.00 USD
Precio habitual Precio de oferta $2.00 USD
Oferta Agotado
Los gastos de envío se calculan en la pantalla de pago.
Material
Estilo

Listing is for a ready to apply transfer for hair claw clip. Print only, ready to apply. Claw clip not included.

Default print size: up to 3.9" wide, up to 1.3" tall

Inludes 2 pcs (1 set) of prints for both sides

media options

General Sublimation Instructions • Preheat the heat press to 380-400°F. Set the time to 50-60 sec., set pressure to medium-heavy. • Remove protective masking and place product blank face down onto the printed transfer. Secure the product blank to the transfer paper with heat tape. • Place blowout paper or Teflon sheet onto the heat press platen. • Place the product blank with attached transfer onto the sheet blowout sheet, with transfer side up. • Place another piece of blowout paper or Teflon sheet on top of the transfer sheet. • Close and press for recommended time. • When finished, open heat press and remove the product. Remove the transfer paper and discard.

UV DTF - printed with UV cured waterproof inks directly onto adhesive, no excess media to weed. Transfer film is included and already applied. Peel cover sheet off, apply transfer, firmly press all printed areas onto the surface, push any bubbles out to the closest edge. Peel transfer film at up to 180 degree angle to remove (roll carrier film back against the surface rather than out away from the surface to minimize pulling pressure on the transfer) leaving the transfer on the glass. No heat/cup press needed. Does not have to be sublimation coated, adheres to glass metal plastic and other hard substrates.

Ver todos los detalles